Beautiful design, seamless functionality. The Nebia Shelf is made from high-quality aluminum, one of the most recyclable materials in the world, and can be uninstalled easily in just a few minutes.
Tools needed before getting started:
- Hairdryer
- Rubber dish gloves
- Flat blade screwdriver or an Ice scraper
- Plastic scraper, box cutter, or razor blade
- Goo-gone adhesive remover
- Microfiber cloth
Getting started:
Apply Adhesive Remover
Heat up the adhesive: Set the hairdryer to max heat while aiming the hairdryer towards the rear of the shelf (between your tile wall and the L bend) for 90 seconds.
Remove the shelf from the wall: While wearing gloves, begin pulling the top of the shelf out from the wall gently. The adhesive will gradually begin to split apart/pull away from the wall. If you’re having trouble with this step, repeat step one (reheat the adhesive) and try again. In addition to heating and stretching the adhesive, you can use a box cutter or razor blade to cut through the adhesive while continuously pulling the shelf away from the shower wall.
Clean the tile: After the shelf is removed, use a citrus-based 3M Adhesive Remover or Goo-Gone to soften any remaining adhesive residue. Use a plastic scraper (or a razor blade for very flat surfaces) and a microfiber cloth to help remove the remaining residue. You may need to repeat step three a few times (spraying, soaking, scraping, and wiping) to completely remove the adhesive residue.
When you're ready to reinstall your Nebia shelf you'll need replacement adhesive. You can order replacement adhesive by clicking here.