Before installing Nebia by Moen remove the wand plug:
Your shower may come with a plug installed at the base of the bracket (pictured below). If you have a wand be sure to remove the plug before installing your Nebia by Moen.
If you have already installed the shower onto the wall follow these steps below:
- To remove the plug, first, make sure the unit is disconnected from the wall.
- To disconnect it, push the button on the top of the wall bracket, and then lift up and outward on the wall bracket to unhook it from the bottom bracket retainer (step 1 & 2, see below).
- Then, on the back of the wall bracket, near the bottom, there should be two black buttons. Push the button for the port containing the wand plug.
- While the button is depressed, pull out the plug. Finally, re-mount the wall bracket by sliding the base of the bracket onto the bottom bracket retainer, pressing it back into the collar, and finally click in the Wand. These steps are shown on page 3 of the document Nebia by Moen Handhower set-up guide.
Install guide links: