Take out the head, bracket & arm, arm cover, L-key, and screws from the box.
Rest the bracket & arm upright so that the bottom makes contact with a flat surface. If this is difficult, rest the bracket & arm on its side on a flat surface. To prevent scratches, a towel can be placed underneath the unit.
- Attaching the head to the arm
Position the showerhead on the arm (it should snap in place). Mount the head Fasten all four screws in position and tighten them using the L-key firmly.
- Attaching the hose
Attach the end of the bracket & arm hose to the Y connector making sure it goes in all the way. Water will gush out from this connection when the shower is turned ON if the tube is not fully seated.
- Attaching the arm cover
Snap arm cover in place. Ensure the hose exits the rear of the arm cover through the notch. Insert the front-side of the arm cover first, then work your way down the rear making sure every snap is engaged properly.