- Peel the protective layer off of the adhesive.
- Position the Dock in your desired location and press firmly for 30 seconds.
- Wait 20 minutes before placing the Wand on the Dock or turning the water, to ensure secure adhesion.

Having troubles with this step?
The Dock is not sticking to my shower wall.
If your shower wall was not cleaned and dried properly or if the wall is made of slate, the adhesive will not be able to adhere correctly. Please make sure your shower wall is clean and dry before reinstalling the Dock. Inside the Cleaning Cap in your Toolkit, you will find an extra strip of Adhesive. Place the new Adhesive over the current one and try again to install the Dock.
The Dock got wet before the Adhesive had time to dry and fell off.
Please be sure the shower wall has been cleaned and thoroughly dried. If the adhesive ended up getting wet, don’t worry, there’s an extra strip of adhesive with the cleaning caps. Replace the adhesive and repeat step 09 in the setup guide.
Why do I have to wait 20 minutes after installing before I can try my new shower?
The adhesive needs time to set before you used the Nebia shower. The 20 minute dry time ensures that you will not have problems with the adhesive falling off.
I decided I want to move the Dock to another location, how do I remove it?
If you need to move the dock, we have a few recommendations that will help. First, start by applying a small amount of rubbing alcohol at the base of the dock (this will help break down the adhesive bond) and wait around 20. Next, you will need to use a putty knife, spatula (even an ice scraper will work) to remove the dock from your wall. After removing the dock, you will need to use the spare adhesive (found in with the cleaning cap kit) to reinstall. You can watch a video of this process at the end of the uninstallation video.